Ningbo Joystar Tools Co., Ltd.  

Product Name: 9cc cup new material airbrush (TJ-180) Model NO.: TJ-180 Disposable: Non-Disposable Usage: for Cosmetic, for Nails, for Hair, Body Art Type: Airbrush Paint Working Pressure: 15-50 Psi Feed Type: Gravity Feed Use: Body, Nail, Face Nozzle Dia.: 0.2mm, 0.3mm, 0.5mm Customized: Customized Condition: New Color: Red, Gold, black Trademark: JOYSTAR Transport Package: Plastic Box Specification: 9cc cup capacity Origin: Ningbo HS Code: 84242000 Product Description Product Name: AirbrushModel: TJ-180Specification:Nozzle Diameter: 0.2mm, 0.3mm, 0.5mmNluid Cup Capacity: 9ccOperating Pressure: 15-50 PSISwitch Mode:Dual-Action Trigger ControlPaint Distance:50 ~ 100mmLength of Spray Pen: 5.67″/ 14.4 cmColor: Red, Black, GoldPackage:Carton Dimension: 39x56x21CMPCS/CTN: 50N.W./G.W.: 5.1 / 6.6KGUsed for: Airbrush makeup,Airbrush tattoo,Airbrush tanning,Finger nail art,Automotive, Cake, HobbyHow to clean the airbrush:Setp1:After spraying your project and your ready to clean the paint from the Airbrush, or you are just ready for a color change, discard the paint from the color cup with a squeeze bottle and use a cleaning brush to clean the color cup immediately. Remember to never let any paint dry or sit in the Airbrush as this will cause a world of problems for you.Step2:Now, using a bucket of fresh water (the bucket is to minimize over-spray in the air), submerge the Airbrush underwater and perform the "flush and back-flush" steps. This is where you allow clean water to run through the Airbrush and then allowing water to back-flush any pigment inside of it. This is achieved by "plugging" and "un-plugging" the tip (needle cap) of the brush with your finger. Do this 10-20 times underwater or until clean.Step3:Note: Although the color cup and airbrush visibly appear to be clean, there may still be pigment inside the body of the brush AND on the needle. Remove the needle by loosening the needle chuck and wipe the needle clean. While the needle is out, you can flush and back-flush the Airbrush through fresh water to insure it is 100% clean. Now you can gently replace the needle. (be very soft handed and be careful replacing the needle as to avoid damaging the fluid nozzle.)Step4:Airbrush cleaner can now be added to the brush to eat away any stubborn paint still inside the brush. (If you are using auto paint, use reducer as your cleaner). Flush and back-flush a few times and spray out the cleaner to get a visual spray test. If a sputtering or spitting pattern comes out, your brush is still dirty and you will need to repeat steps 1-4.